Appendix B, Section 14

The Lengths AM Stations Go To: The Engineering Behind the Signal

Part of AM Radio Facts and Trivia: The AM Broadcast Band in the USA. Updated November 17, 2026.

Putting an AM signal on the air takes far more than a transmitter and a tower. AM stations aim their signals with rows of towers, change patterns at sunrise and sunset, bury miles of copper under the field, share towers with other stations, and keep backups for everything. This page gathers those feats in one place, each with a short summary and a link to the full story.

Shaping Where the Signal Goes

Most AM stations share their frequency with distant stations. Rather than simply cutting power, many build antennas that aim the signal where the listeners are and hold it back where it would interfere.

Directional Arrays (Chapter 2, Section 3). Two, three or more towers fed at carefully set timing and strength combine their signals so they add up in some directions and cancel in others. This is how AM went from wires on rooftops to the patterns that shape almost every signal on the dial.

The Three-Phasor Club (Chapter 3, Section 3). A few stations run three different directional patterns every day, one for daytime, one for critical hours and one for night, each with its own settings and its own proof to keep legal. They are the most complex AM antenna operations in the country.

Critical Hours (Chapter 6, Section 14). In the two hours after sunrise and the two before sunset, the sky starts to carry signals farther than in full daylight. About 170 stations cut power or switch patterns during those hours to protect distant clear channel stations.

Throwing the Switch at Sunset and Sunrise (Chapter 3, Section 5). Directional stations change patterns as day turns to night and back. Before automatic relays and timers, an engineer at the transmitter made that switch by hand, every day of the year.

Daytime-Only Directional (Chapter 6, Section 13). A rare mode: a station that runs its towers as a directional array by day, then drops the array and goes non-directional at night at a small fraction of the power.

Separate Day and Night Transmitter Sites (Chapter 8, Section 3). Most stations broadcast from one site around the clock. Some keep two entirely separate transmitter sites, sometimes miles apart, one for daytime and one for night.

Detuning Cell Towers (Chapter 3, Section 11). A new steel tower near an AM station can pick up its signal and re-radiate it, bending the pattern. Since the 1980s, cell towers near AM arrays have had to be "detuned" with special wiring so they stay invisible to the AM signal.

Making the Tower Do More

On AM, the tower is not something that holds the antenna up. The whole steel tower is the antenna, and engineers have found many ways to make it work better, or to make something else serve as one.

The First Vertical Radiator: WABC, 1931 (Chapter 2, Section 2). The idea that the whole energized steel structure radiates the signal was not always obvious. This is the story of the first tower used that way, with two calculators that show how tower height and efficiency work.

Feeding the Tower (Chapter 2, Section 5). There are five classic ways to get the power into an AM tower: series fed on a base insulator, shunt fed, skirt fed, top-loaded and sectionalized, each with its own FCC code.

The Capacity Hat (Chapter 2, Section 6). A ring or spokes of wire at the top of a tower make it act electrically taller than it really is, without adding a single foot of steel.

Ground Radial Systems (Chapter 2, Section 7). The tower you can see is only half of an AM antenna. The other half is underground: usually 120 copper wires spreading out like the spokes of a wheel.

Inside the Tuning House (Chapter 2, Section 4). At the foot of each tower sits a small building holding the tuning unit, plus the insulator the whole tower stands on and the special transformer that carries power for the lights across it.

Antenna Oddities and Unusual Designs (Chapter 2, Section 9). Franklin arrays, sectionalized towers, synchronous boosters and other one-of-a-kind designs that engineers built to solve unusual problems.

Borrowed and Disguised Radiators (Chapter 2, Section 10). AM antennas hidden in flagpoles, smokestacks and even a church, going back to KDKA's 1920 election broadcast from a wire hung on a smokestack.

Rooftop AM Towers (Chapter 8, Section 2). Before stations moved out to cheap land, many put their towers on hotels, office buildings and nightclubs, and a few still do. Here is how they make a rooftop work.

Sharing and Staying on the Air

Land and towers are expensive, and dead air loses listeners. Stations share what they can and plan for things to go wrong.

Diplexing (Chapter 3, Section 8). Two or even three AM stations on different frequencies can share the same tower or array at the same time, kept apart by filters.

The Standby Tower (Chapter 8, Section 10). Serious stations keep a licensed backup tower, transmitter and generator. KFI stayed on the air for years after a plane felled its main tower.

Getting the Audio to the Tower (Chapter 4, Section 7). Every way stations carry their programs from the studio to a distant transmitter, from phone company wires to microwave and internet codecs, and the backup systems that keep them on the air when a link fails.

The Shrinking Transmitter (Chapter 15, Section 14). Transmitters that once filled a building now fit in one cabinet, and the empty space has become backup studios. Includes the drawing of four 50,000 watt transmitters to scale.

Building the Transmitter

Turning electricity into 50,000 watts of clean, loud radio signal took decades of clever engineering, and still costs a station a large electric bill.

Motor-Generator Sets (Chapter 4, Section 3). Before high-voltage rectifiers, stations used spinning machines to make the clean direct current their transmitter tubes needed.

Doherty and Ampliphase (Chapter 4, Section 6). How engineers made 1930s tube transmitters far more efficient, and why one of those tricks now runs inside your cell phone.

Transmitters That Pay for Themselves (Chapter 4, Section 5). Modern solid-state transmitters cut the power bill so much that they have helped some high-power stations stay on the air instead of going dark.

The Loudness Wars (Chapter 4, Section 2). From early engineers riding the volume by hand to audio processors that could make a 5,000 watt station sound like 50,000, AM stations fought to be the loudest on the dial.

NRSC-1 and the 10 kHz Ceiling (Chapter 15, Section 2). Into the 1980s, nothing limited how wide a station's audio could spread. This is the standard that ended the splatter, and why AM sounds the way it does.

Safety and Survival

An AM tower carries enough radio energy to burn, and the steel stands through lightning, storms and earthquakes for decades.

The "Jesus Stick" (Chapter 5, Section 2). The grounding stick hanging inside every transmitter cabinet, and why no engineer reaches into a transmitter without using it first.

Grounding the Building (Chapter 5, Section 3). An AM transmitter site uses more copper than almost any other small building in the country, and every bit of it is there for a reason.

Paint or White Strobes (Chapter 2, Section 12). Why tall towers wear orange and white bands or flash white strobes, and the FAA rules that decide which.

Loma Prieta and the AM Towers, 1989 (Chapter 8, Section 13). The 1989 earthquake did something earthquakes rarely do: it brought down AM broadcast towers in the Bay Area.

Replacing an Aging Array (Chapter 8, Section 11). Many towers on the air today were built from the 1930s to the 1960s. What it costs in 2026 to replace a three-tower array one tower at a time while staying on the air.

The Physics Behind It All

Every one of these feats starts with how an AM signal travels.

Groundwave, Skywave and the Ground Under the Tower (Chapter 1, Section 2). By day AM signals hug the ground, and at night they bounce off the sky. How wet or dry the soil is decides how far a station reaches. Includes the "Why the Dial Changes at Night" interactive.

Ground Loss and Frequency (Chapter 1, Section 3). Why a station at 600 kHz reaches farther by day than one at 1500 kHz with the same power.

Why the Bottom of the AM Band Dies First (Chapter 1, Section 4). Two stations, same power, same market: the one lower on the dial is far harder to keep alive. Here is why.

Try the Tools

Many of these stories come with hands-on simulators and calculators: directional arrays, the phasor, tower height and antenna efficiency, and more. They are all gathered on AM Radio Interactive Tools and Simulators (Appendix A, Section 1).

About this page: the summaries above are drawn from the linked pages on this site, where the full stories and their sources are given.

© 2026 Chris, N6JET. Free to read and share for non-commercial use with credit (Creative Commons BY-NC 4.0). Not for sale.

More in Reference

All AM radio stories by subject · AM radio interactive tools and simulators · AM Trivia Challenge quiz