Chapter 4, Section 6
Part of AM Radio Facts and Trivia: The AM Broadcast Band in the USA. Updated November 15, 2026.
A technical companion to Who Built the Transmitters and The Transmitters That Pay for Themselves: how engineers in the 1930s wrung efficiency out of giant tube AM rigs, and why one of their tricks quietly runs your cell phone today.
An early high-power AM transmitter was, electrically, a space heater that happened to make radio. The problem is built into old-fashioned amplitude modulation: to be ready for the loudest peaks, the final tubes have to idle near full tilt all the time, even during silence. The numbers were brutal. RCA's 1 kW "1B" drew about 13,000 watts from the wall to put 1,000 watts into the antenna, roughly 7.5% efficient. Western Electric's 7A, one of the first commercial 50 kW rigs, swallowed some 230,000 watts for a 21% return. The rest went up the stack as heat. As the Depression deepened and stations clamored for ever-higher power, the electric bill became the enemy.
Plate efficiency, conventional 1930s rigs vs. the Doherty amplifier.
Drawing 4.6-1
Doherty's insight (1936). William H. Doherty, an engineer at Bell Telephone Laboratories, found a way to keep the tubes efficient across the whole modulation cycle. His amplifier splits the work between two tubes: a carrier tube that does the steady job of the unmodulated signal, and a peak tube that wakes up only on the loud peaks. A clever quarter-wave coupling network, with the two tubes driven 90° out of phase, makes the carrier tube "see" a changing load as the peak tube kicks in, so both run near their efficient sweet spot instead of idling hot. The payoff: plate efficiency of roughly 60-65%, independent of modulation (triple the old designs) and as a bonus it eliminated the enormous, room-filling modulation transformer that conventional high-level rigs needed.
The Doherty idea: split steady vs. peak duty between two tubes so neither wastes power idling.
Drawing 4.6-2
Ampliphase, the rival approach. RCA needed an answer that dodged Western Electric's patent, and found one in an older idea: outphasing, proposed by Henri Chireix in 1935. The trick is almost magical: take two carriers of constant amplitude, and vary the phase angle between them. When they're nearly aligned they add up; when you swing them apart they partially cancel. Modulate the phase difference and the sum comes out as an ordinary AM signal, all while the tubes themselves never change power, so they stay efficient. RCA bought the patent (by way of McClatchy Broadcasting) and marketed it as Ampliphase, first at 50 kW and later in 10 kW and 5 kW models. It was clever, compact, and notoriously fussy to keep in tune.
And a third: the Sainton amplifier. The story didn't end there. Continental Electronics (the firm with deep roots in this site's transmitter history) refined the Doherty idea with a screen-modulated variation patented by Joseph Sainton in 1967, building an entire 50,000-watt transmitter with just nine tubes. Continental's CE 317C became the runaway favorite: nearly 300 installed in North America alone, more than all competitors combined.
| Technique | Origin | How it saves power | Marketed by |
|---|---|---|---|
| Doherty | W. H. Doherty, Bell Labs, 1936 | Carrier + peak tubes; load shifts so both stay efficient | Western Electric |
| Ampliphase (outphasing) | Chireix, 1935 → RCA | Two constant-power carriers; vary the phase angle between them | RCA |
| Sainton (Doherty variant) | J. Sainton, Continental, 1967 | Screen-modulated Doherty; far fewer tubes | Continental Electronics |
Table 4.6-3
The twist: the old idea is everywhere again. Tube-era AM is mostly history, and the last Ampliphase rigs are museum pieces: KFBK in Sacramento reportedly kept an RCA BTA-50H as a standby, the "last gasp" of the concept. But Doherty's 1936 circuit had an astonishing second life. The same carrier-plus-peak principle, rebuilt in solid state, is now the workhorse of modern radio: it's how cellular base stations and digital TV transmitters stay efficient while handling signals with big peaks. A circuit invented to trim a Depression-era radio station's light bill is, right now, helping power the phone in your pocket. For the companies and rigs behind these transmitters, see Who Built the Transmitters; for the modern efficiency fight, see The Transmitters That Pay for Themselves.
Sources: Radio World ("Reinventing Bill Doherty and His High-Efficiency Amplifier") · Wikipedia (Doherty amplifier; William H. Doherty; Ampliphase) · ScienceDirect (Doherty power amplifier overview) · Continental Electronics history.
© 2026 Chris, N6JET. Free to read and share for non-commercial use with credit (Creative Commons BY-NC 4.0). Not for sale.
All AM radio stories by subject · AM radio interactive tools and simulators · AM Trivia Challenge quiz