Chapter 4, Section 2
Part of AM Radio Facts and Trivia: The AM Broadcast Band in the USA. Updated November 15, 2026.
Loudest on the dial. On a crowded AM band, program directors held one article of faith: the listener spinning the dial stops on the station that jumps out of the speaker. Louder sounded closer, bigger, more powerful: a 5 kW station with aggressive processing could sound “larger” than a lazy 50 kW. So every competitive station in America chased the same title, loudest on the dial, and an entire industry of gain-riding hardware grew up to win it.
Before the war: the gain riders. The first processors existed for legality, not loudness: AM overmodulation splatters, so something had to catch the peaks. Through the 1950s that meant simple compressors from the transmitter makers: the Gates Sta-Level and Level Devil, the RCA BA6A, boxes that did the job but “breathed,” audibly pumping the background noise up during every pause.
The Maxx brothers. In 1959 CBS Laboratories, the network’s R&D arm under Dr. Peter Goldmark, changed the game with the Audimax, a “smart” gated automatic gain control designed around psychoacoustics by Emil Torick: it held levels rock-steady across a wide gain platform but froze when the audio paused, killing the noise-breathing that plagued everything before it. Its partner the Volumax was a peak limiter with a moderate attack feeding a final clipper; and the AM version clipped asymmetrically, exploiting the FCC’s asymmetric modulation rules that allow positive peaks well past 100%. The first tube units cost as much as a new car; the solid-state 400 series that followed put an Audimax/Volumax pair (engineers called them the Maxx brothers) in nearly every serious air chain in America for over a decade. Hot-rodders knew the tricks: swap one resistor in the Audimax for a zero-ohm jumper and the compression went from smooth to crushing.
Escalation. Single-band processing could only go so far: squeeze everything with one gain control and the bass pumps the highs. In 1971 Mike Dorrough’s Discriminate Audio Processor split the audio into bands, each compressed separately, and the multiband era began: denser, louder, more consistent. Top-40 engineers built custom chains, piled on high-frequency pre-emphasis to punch through dull car radios, and pushed occupied bandwidth to 30 kHz and beyond, the very splatter arms race that eventually forced the industry to negotiate NRSC-1.
The Optimod. In 1977 Bob Orban’s Optimod-AM arrived and reset the board: a receiver equalizer that pre-compensated for the rolled-off radios of the day, a distortion-canceling clipper that got loudness without the grunge, and tight bandwidth control ahead of the FCC’s occupied-bandwidth rules. It did to AM processing what its FM sibling had done two years earlier, so thoroughly that “Optimod” became the generic word for an audio processor, the way Kleenex means tissue.
Drawing 4.2-1
The Trivia. The loudness war never really ended; it just declared its winner the sound of the medium: virtually every commercial AM signal you have ever heard passed through heavy processing, and “the AM sound” is largely the sound of the boxes. WTIC Hartford’s Volumax was said to have carried the station through ten consecutive ratings books at number one. FCC rules still permit AM positive modulation peaks of up to 125%, the legal asymmetry the Volumax’s clipper was built to exploit. And surplus Audimax/Volumax pairs remain prized by AM enthusiasts today, still getting rebuilt and racked up decades after CBS Labs closed the books.
© 2026 Chris, N6JET. Free to read and share for non-commercial use with credit (Creative Commons BY-NC 4.0). Not for sale.
All AM radio stories by subject · AM radio interactive tools and simulators · AM Trivia Challenge quiz