Chapter 4, Section 7

Getting the Audio to the Tower: Studio-to-Transmitter Link Methods and Backups

Part of AM Radio Facts and Trivia: The AM Broadcast Band in the USA. Updated November 17, 2026.

Most AM stations do not broadcast from the building where the programs are made. The studios are in town, near the advertisers and the people, while the towers stand out in the country on acres of open land. Something has to carry the audio between them, every second the station is on the air. That something is the studio-to-transmitter link, or STL. This page explains the ways it has been done, from phone company wires to today's internet codecs, and the backup systems stations use so a single failure does not leave dead air.

Why the Studio and the Transmitter Are Apart

In the earliest days, many stations put the transmitter on the roof of the studio building. It did not work well: steel buildings nearby soaked up and bent the signal, and a rooftop has no room for a proper ground system. As power went up, stations moved their transmitters to open land. KDKA in Pittsburgh moved its transmitter out of downtown, finally to Allison Park in 1937, while its studios stayed in the city. Directional arrays made the move even more necessary, because they need several towers and acres of buried copper.

Remote control made separate sites practical. In 1953 the FCC allowed non-directional AM stations up to 10,000 watts to run their transmitters by remote control, and in 1957 it extended that to high-power and directional stations. From then on, the studio sent the audio and the controls, and the transmitter site could sit unattended miles away.

The Methods

Phone company program lines

For most of the 20th century, the audio rode on special lines leased from the phone company. These program lines were equalized to carry more of the audio range than a phone call: 5,000 cycles (5 kHz) for many stations, 8 kHz for better grades, and 15 kHz for full-range music. Stations paid by the month, by the grade and often by the mile. Engineers had little good to say about them late in their life: one called telco 15 kHz pairs "a crap shoot."

They are now disappearing. The FCC has spent a decade making it easier for phone companies to retire copper lines, most recently in a March 2026 order. AT&T has announced plans to retire most of its copper network by 2029. Few stations still depend on a program line, and those that do are being moved off.

The 950 MHz microwave STL

The classic STL is a licensed microwave radio link. The FCC sets aside 944 to 952 MHz for broadcast studio-to-transmitter links (47 CFR 74.502), divided into 25 kHz pieces that a station can combine into a channel up to about 300 kHz wide. A transmitter at the studio feeds a dish or grid antenna aimed at a matching antenna at the transmitter site. The path needs a clear line of sight, and links of 10 to 30 miles are common, with about 50 miles possible from good heights. The link is licensed through the FCC, and frequencies are coordinated so stations do not interfere with each other. In big cities the band is so crowded that a new channel can be hard to find.

Older 950 MHz links send analog audio; newer digital ones send near-perfect audio and can carry several stations on one channel. One engineer estimated in 2025 that thousands of US stations still use 950 MHz, and some recommend keeping it as a backup even when internet is the main path, because it does not depend on any outside company. A new digital system lists for about $10,000 to $19,000 before antennas and installation.

T1 and ISDN lines

In the 1990s and 2000s, many stations used digital phone company circuits. A T1 line carried CD-quality stereo with almost no delay, often through Intraplex equipment. ISDN lines, with codecs such as the Telos Zephyr introduced in 1993, carried compressed audio and were popular for remote broadcasts. Both are fading: phone companies have stopped selling new ISDN service and are discontinuing T1 circuits, and prices for what remains have risen.

Internet audio codecs

Today the most common STL is the internet. A codec at the studio turns the audio into data packets, and a matching codec at the transmitter turns them back into sound. Stations can send uncompressed audio when the connection is fast enough, or use compression formats such as Opus or AAC. The receiving codec holds a small buffer so late packets can still be used. The trade-off is delay: from under 25 thousandths of a second for uncompressed audio to a fraction of a second with heavy compression and buffering. Popular codecs include Comrex BRIC-Link, Tieline, Barix, GatesAir Intraplex and WorldCast APT, at about $400 to $5,000 per end. One radio engineer wrote in 2025 that internet delivery "has become the default."

Wireless Ethernet radios

Another popular choice is a pair of point-to-point Ethernet radios, which act like a long invisible network cable. Unlicensed radios in the 5 GHz band cost from a few hundred to a few thousand dollars a pair; one 13 mile link serving four stations cost about $4,600. They have no protection from interference, though, because unlicensed users must accept it. Licensed microwave in the 11, 18 and 23 GHz bands avoids that, but heavy rain weakens the higher frequencies, so 23 GHz links are usually kept to a few miles.

Fiber, cellular and satellite

Where fiber reaches the transmitter site, it is fast and reliable, until a backhoe cuts it. Engineers call that "backhoe fade." Cellular data (LTE and 5G) and satellite internet such as Starlink are now common at rural sites with no wired service, most often as backups. Starlink can drop out for minutes during software updates and has trouble with ice and snow, so engineers warn against relying on it alone. Older geostationary satellite internet has too much delay for most STL use.

Off the air

FM translators often pick up their main station right off the air. A full-power station can also be fed off the air from a sister station, but FCC rules require written consent to rebroadcast another station, and the audio gets processed twice.

All the paths in one picture

FROM STUDIO TO TOWER: THE PATHS AUDIO CAN TAKE STUDIO in town Air chain TRANSMITTER SITE out in the country Silence sensor and switch Backup audio player (stored shows) Xmtr Tower Phone company program line (old, being retired) 950 MHz licensed microwave, dish to dish Internet: IP audio codecs at both ends Wireless Ethernet radio (5, 11 or 18 GHz) Cellular or satellite (often the backup) Most stations now run at least two of these paths, so one can fail without silence on the air.

Drawing 4.7-1

Comparing the Methods

MethodCostAudioDelayWhat goes wrong
Phone company program lineMonthly lease5 to 15 kHzAlmost nonePhone company outages; being retired
950 MHz microwave, analogAbout $9,000 to $42,000 installedUp to 15 kHzAlmost noneInterference, fog, ice on antennas
950 MHz microwave, digitalAbout $10,000 to $19,000 equipmentNear perfectVery lowPaging transmitters can knock it out of lock
T1 lineMonthly, risingCD qualityVery lowCable cuts; being discontinued
Internet codecs$400 to $5,000 per end, plus internet serviceNear perfect to compressedAbout 0.02 to 0.15 seconds, plus bufferInternet outages, delays, computer updates
Unlicensed wireless EthernetA few hundred to a few thousand dollars a pairNear perfectVery lowInterference, trees or buildings in the path
Licensed 11 to 23 GHz radioRadios plus about $1,000 to $2,000 coordinationNear perfectVery lowHeavy rain at higher frequencies
Cellular or StarlinkMonthly data planCompressedVariesSoftware updates, snow and ice, data limits

Table 4.7-2

Backup Systems: Staying on the Air When a Link Fails

No FCC rule requires a backup STL. But a station that goes silent loses listeners within minutes, misses the ads it was paid to run, and, if the silence lasts, has to file notices with the FCC. Commercial stations must stay on the air a minimum schedule each day (47 CFR 73.1740) and must tell the FCC by the tenth day if they are off the air or on reduced power. Emergency Alert System equipment must also keep working. Every engineering source we found gives the same advice: at least two paths, and test the backup often.

Two paths, two technologies

The first rule is diversity. A station might run its main audio over the internet and keep a 950 MHz microwave link as backup, or use two different internet companies, or a wired line plus a cellular or wireless radio link. The paths should not share a weak spot: in one 2023 case in Colorado, a station's T1 line and its DSL backup were both on the same phone wire, and both died when that wire was cut. Engineers also warn about shared power supplies and single codec boxes.

Seamless codecs that use two paths at once

Modern internet codecs can send the same audio over two or more paths at the same time. The receiving codec takes whichever copy of each packet arrives first and throws away the duplicate, so if one path fails, listeners hear nothing at all. Comrex calls this CrossLock, Tieline calls it SmartStream Plus, GatesAir calls it Dynamic Stream Splicing, and WorldCast APT sells a box called SureStreamer. A cheaper approach keeps the backup connection idle until the main one fails, then switches; that saves data charges but leaves a short gap.

Silence sensors and automatic switching

At the transmitter site, a silence sensor listens to the program audio. If it goes quiet for a set number of seconds, the sensor switches to a backup source and sounds an alarm. These boxes cost about $230 to $620. Some transmitters and audio processors have the same feature built in. When KQED's Sacramento station lost its T1 and ISDN lines for nearly a week in 2016, a switcher flipped it to an internet backup automatically and it stayed on the air.

A backup audio player at the transmitter

If every link fails, a player at the transmitter site can play stored programming: music, station IDs and ads loaded in advance. Some codecs have this built in on a memory card. In 2009, a construction crew cut both of one station's T1 lines, which ran in separate cables. The outage lasted 9 days, 2 hours and 26 minutes. The station stayed on the air by moving an automation computer to the transmitter site and updating it twice a day.

Alarms that call the engineer

Transmitter remote control systems, such as those from Burk and Davicom, can text, email or phone the engineer when the audio stops or a link drops. Engineers warn that the alarm should not depend on the same internet connection as the STL; when the internet dies, the alarm dies with it.

A backup studio at the transmitter site

Since the FCC eliminated the main studio rule in January 2018, a station can broadcast from anywhere, including its transmitter building. Many stations now keep a small backup studio there, often in the room an old tube transmitter once filled. If the link to town fails completely, someone can drive to the site and broadcast from there. For more on that, see Chapter 15, Section 14 and Drawing 15.14-1 on the AM trivia page.

A warning: backups can be a door for hackers

In November 2025, intruders took over at least two stations through internet audio equipment that had not been secured, including a backup feed that a silence sensor had switched to. Listeners heard fake emergency alert tones and obscene audio. The FCC issued a public warning to broadcasters. A backup path needs the same passwords, updates and firewall protection as the main one.

Real Outages and How Stations Handled Them

WhenStationWhat failedWhat happened
August 2009A station (unnamed)Construction crew cut both T1 linesStayed on the air for 9 days from an automation computer moved to the transmitter site
2013A station in a John Bisset column, Radio WorldPhone company office power failure, 5 hoursFed the transmitter from a smartphone playing the station's internet stream
2016KQED's Sacramento stationT1 and ISDN lines down nearly a weekSwitcher flipped automatically to an internet backup
2017Christian Family Radio, Bowling Green, KentuckyFiber link dropping out several times an hourDual-path codec made the dropouts inaudible
October 2023Two AM stations, Fountain, ColoradoPhone wire cut near the siteThe transmitter EAS box still received the national test over the air
September 2024WMIT 106.9, North Carolina (Hurricane Helene)Widespread power and internet lossOff the air only about 5 minutes; 950 MHz link, and Starlink at the studio
November 2025Two stations in Virginia and TexasUnsecured backup internet audio equipmentHijacked; FCC issued a public warning

Table 4.7-3

What It Tells Us

For seventy years, the studio-to-transmitter link was a wire rented from the phone company or a microwave beam the station owned. Now it is mostly the internet, which is cheap and good but depends on other companies and needs protection. The stations that stay on the air through storms and cable cuts are the ones that planned for failure: two different paths, an automatic switch, something stored at the transmitter, and an alarm that reaches a person.

Sources: FCC rules 47 CFR 74.501, 74.502 and 74.531 (aural STLs), 73.1740 and 73.1560 (minimum schedule and silence notices), 11.35 (EAS), 73.1207 (rebroadcast consent), 15.5 (unlicensed radios); FCC orders on copper retirement (15-97, 2015; 17-154, 2017; 26-19, March 2026), the 2012 Part 101 final link order and the 2017 main studio order; FCC public notice on broadcast hijacking (November 2025); FCC annual report 1953 and Broadcasting (remote control); Bell Telephone Quarterly (1934); Bell Labs (1949); bayarearadio.org (Fred Krock); Radio World articles by Doug Irwin (2006, 2013, 2016, 2018), Cris Alexander (2004, 2010), Tom Vernon (2004), Paul Thurst (2011), Jeremy Ruck (2016), Kirk Harnack (2016), John Bisset (2013), Jim Withers (2012), William Harrison (2025), Tommy McElmeel (2025), Josh Bohn (2023, 2025), Robbie Green (2026), Cutforth (2023), and on KQED, WMIT, Comrex and Tieline; Radio Ink, TheDesk and The Register (2025 hijackings); engineeringradio.us (2009 T1 outage); thebdr.net (2014, 2016); Comrex, Tieline, GatesAir, WorldCast APT, Telos and Moseley product pages; BSW, SCMS, BGS, Markertek and Full Compass dealer prices; Telecompetitor (AT&T copper plan, 2024); Starlink support. A note on the numbers: prices are dealer listings and published examples, and most claims have fewer than five sources; check current prices with dealers.

© 2026 Chris, N6JET. Free to read and share for non-commercial use with credit (Creative Commons BY-NC 4.0). Not for sale.

More in Modulation and Transmitters

All AM radio stories by subject · AM radio interactive tools and simulators · AM Trivia Challenge quiz