Chapter 14, Section 20

SDR Tools for AM DXing: Recording the Band and Cutting the Interference

Part of AM Radio Facts and Trivia: The AM Broadcast Band in the USA. Updated November 16, 2026.

For most of a century, chasing distant AM stations meant sitting up at night with one radio, one antenna and one frequency at a time. If you were tuned to 1490 at the top of the hour, you missed what was on 1230. The software-defined radio, or SDR, changed that. It can hear the whole AM band at once, record all of it, and let you go back later and pull a weak station out from under a strong one.

The tools are changing so fast that even longtime DXers say they cannot keep up. This page is a plain starting point: what the pieces are, what they do, and what they cannot do.

Chapter 14, Section 20, Part 2

What an SDR Is

An SDR is a small receiver box, usually connected to a computer by USB, that turns a wide slice of the radio spectrum into numbers. The computer does the rest: tuning, filtering and turning the signal into sound. Instead of a dial, you see a waterfall, a moving picture of every station in the band, with stronger signals shown brighter. You can click on any of them to listen.

Because the software does the work, the same box gets better as the software improves. Several of the tools on this page did not exist a few years ago.

Live listeningAntennaSDR receiversmall box; turnsradio into numbersUSBComputerdoes the tuning,filtering andthe soundWaterfall: every station at once530 kHz1700 kHzbrighter line = stronger stationRecord now, listen laterI/Q recordingthe whole band,530 to 1700 kHzabout 900 MBPlay it back latertune any channel,as many timesas you likeCanceller and filtersremove a strongstation on thesame channelAn ordinary recording saves onestation's sound; I/Q saves them allBefore the cancellerstrong localweak distantone channel, carriers a fraction of a hertz apartAfter the cancellerremovedweak distantone channel, carriers a fraction of a hertz apart

Drawing 14.20-2

Chapter 14, Section 20, Part 3

Recording the Whole Band: I/Q Files

The biggest change for DXers is the I/Q recording. An ordinary recording saves the sound of one station. An I/Q recording saves the raw radio signal across the whole slice the SDR is receiving. When you play it back, it is as if you were back at the radio at that moment, free to tune anywhere in the band, as many times as you like.

Receivers that DXers commonly use for full-band AM recordings include the SDRplay RSPdx (in its HDR mode), the Microtelecom Perseus, the Elad S-2 and S-3, and the RFSpace and Cloud-IQ receivers. This page does not recommend one over another.

Chapter 14, Section 20, Part 4

WavViewDX: Reviewing a Night in Minutes

Going through a whole night of recordings one frequency at a time can take longer than the night itself. WavViewDX, written by German developer Reinhard Weiß, was built to fix that. It reads I/Q recordings from most of the common SDR programs and receivers, including Perseus, SDR#, SDRconnect, SDR Console, SDRuno, HDSDR and Linrad.

A member writing in the National Radio Club's DX News in November 2026 reported that a recent version added a co-channel canceller alongside left and right adjacent channel cancellers. She wrote that it let her null strong 50,000 watt local stations completely, and that reviewing two nights of recordings gave her 17 new stations. (That feature report comes from one source; the developer's own page did not list it when this page was written.) Members report that the program runs on Windows, Linux and Mac, and is free.

Chapter 14, Section 20, Part 5

The Co-Channel Canceller in SDR#

The oldest and best known canceller is the AM Co-Channel Canceller in SDR# (also called SDRSharp), the free SDR program from Airspy. It arrived around 2020 and was rebuilt with a stronger version 2 algorithm. Its job is simple to describe: when two stations share a frequency, it removes one of them so you can hear the other.

The basic steps, from DXers who use it:

  1. Set the mode to DSB. The canceller does not work in plain AM mode.
  2. Set the filter to about 8 kHz and tune exactly to the channel.
  3. Open the Micro Tuner and let it settle. It shows each station's carrier as a separate spike, a fraction of a hertz apart.
  4. Click the center of the spike for the station you want to remove, then turn the canceller on and use the smallest correction that does the job.

It works best when one unwanted station is clearly stronger than everything else on the channel. With several stations of similar strength, or heavy splatter from the next channel, results are partial, and a weak cancelled signal can leave a muddy background. A trick DXers use: null one station with a loop antenna, then cancel a second one in software.

Chapter 14, Section 20, Part 6

Can an SDR Reduce Interference?

Yes, for some kinds. No, for others. The table below sorts it out. Green means an SDR tool usually helps, yellow means it helps some of the time, and red means software alone will not fix it.

The problemThe SDR toolWhat to expect
A strong station on the same channel as the one you wantCo-channel cancellerOften works well when one station is much stronger than the rest.
A steady whistle (a heterodyne) from a station a few kHz awayNotch filter; synchronous AM locked to one sidebandA narrow notch can remove the whistle. Locking to the cleaner sideband can avoid it entirely.
Splatter from a strong station on the next channelNarrow filters; synchronous AM on the far sideband; adjacent channel cancellersUsually a big improvement over an ordinary radio.
Strong local stations overloading the receiverA receiver with high dynamic range; careful gain settingsBetter receivers handle it. Filters that block the whole AM band also block the stations you want.
Noise from one nearby source, such as a neighbor's deviceTwo-antenna phasing (diversity), for example the SDRplay RSPduo with SDRuno or SDRconnectSubtracts the noise one antenna hears from the other. One amateur reports 10 dB or more of improvement; results depend on the antennas and the noise.
Clicks and pops: static crashes, ignition, switching spikesNoise blankerBuilt for short sharp bursts. Does little for steady noise.
Steady hissNoise reduction (NR)Takes the edge off. Set too high, it makes the audio sound watery.
A high noise floor from many sources at once, as in a townhouse or apartmentNo software fixIf the noise is as strong as the station, the station is gone before the software sees it. The fix is a quieter antenna location or a remote receiver.

Table 14.20-1

The honest limit. An SDR cannot recover a signal that never rose above the noise at the antenna. Software can separate signals that are different from each other: a carrier here, a whistle there, a noise source in one direction. It cannot separate a weak station from a wall of noise that covers the whole band. That is why the noise problems described in AM Radio Noise at Home are solved at the antenna, not in the computer.

Chapter 14, Section 20, Part 7

Remote Receivers: Borrowing a Quiet Location

If your own location is too noisy, an SDR on the internet may be the answer. Volunteers run KiwiSDR and WebSDR receivers around the world, many in quiet rural places and some near coastlines that face Europe or Asia. Anyone can tune them in a web browser. Most allow a few listeners at a time. The public KiwiSDR list is at kiwisdr.com. Some DXers also record from remote receivers and review the recordings later, the same way they would at home.

Chapter 14, Section 20, Part 8

Where to Learn More

DXers trade new tools and settings constantly. Good places to follow along include the National Radio Club and its DX News, the International Radio Club of America (IRCA) group at groups.io, the SWLing Post and RTL-SDR.com, which regularly cover new SDR tools for medium wave listeners.

Sources: National Radio Club, DX News Vol. 94 No. 4 (November 17, 2026), publisher's note and members' reports; Reinhard Weiß, rweiss.de "Tools for DXers" (WavViewDX formats and features); SWLing Post, Totsuka DXers Circle articles on WavViewDX (October and November 2025); Arctic DX blog (February 2025); RTL-SDR.com, SDR# AM Co-Channel Canceller and v2 updates, Airspy HF+ medium wave review, RSPduo diversity demonstrations; Airspy groups.io; RADIO-TIMETRAVELLER, "Using the SDR Sharp Co-Channel Canceler" (July 2024); SDRplay, "Cancelling Signals using SDRconnect and the RSPduo" (February 2024); Fallows, "Medium Wave Filtering with RSPduo" and "SDR Medium Wave Performance"; SWLing Post, "Using synchronous detection and notch filter to eliminate het noise" (2015); HamSCI, medium wave I/Q recording receiver list; SDR-Radio.com forum (recording bandwidth and scheduler).

© 2026 Chris, N6JET. Free to read and share for non-commercial use with credit (Creative Commons BY-NC 4.0). Not for sale.

More in The Listener's Side: Receivers and DXing

All AM radio stories by subject · AM radio interactive tools and simulators · AM Trivia Challenge quiz