Chapter 14, Section 6
Part of AM Radio Facts and Trivia: The AM Broadcast Band in the USA. Updated November 15, 2026.
If the one-tube regenerative set was the wonder of the 1920s and '30s, the one-transistor radio was its solid-state heir. When the transistor arrived in the 1950s, the same beautiful idea crossed over intact: get the most from the least. A single transistor, a coil, a germanium diode, and a high-impedance earphone could pull a broadcast station out of the air: no tubes, no high voltage, no warm-up, just a flashlight battery and a little ingenuity.
Like the one tube before it, the one transistor earned its keep by doing more than one job. In a reflex circuit, the same transistor amplifies the incoming radio signal, hands it off to a diode to be detected, and then amplifies the recovered audio: double duty from a single device. And Armstrong's old trick carried over without a hitch: wind a feedback coupling into the coil and the transistor becomes a regenerative detector, feeding a controlled trickle of its output back to its input for enormous gain, right up to the edge of oscillation. The squeal, the knife-edge regeneration control, the late-night distance reception, all of it returned, now running on a couple of volts.
Drawing 14.6-1
What turned this from a laboratory curiosity into a kid's-allowance hobby was a single humble part: the Raytheon CK722. Introduced in early 1953, it was the first low-cost junction transistor sold to the general public, and its origin is one of radio's great thrifty stories. Raytheon's hearing-aid transistors that didn't quite make the grade were re-graded and sold to hobbyists; the CK722 was, in effect, a premium part's reject given a second life. It started at $7.60, fell to $3.50, and by 1956 cost ninety-nine cents. Norman Krim, the Raytheon engineer behind it, arranged to sell it through a Boston outfit called Radio Shack, and the company seeded the hobby with design contests and project booklets. Hundreds of magazine projects followed.
The little radios showed up everywhere. In 1955, Popular Electronics launched a column called "Transistor Topics" and ran a one-transistor regenerative broadcast receiver built around the CK722, about as sensitive as a good crystal set, the editors said, but far more selective. General Electric answered with its own hobbyist transistor, the 2N107, and the two parts became interchangeable in countless beginner projects. And just as the tube generation had the Knight-Kit Ocean Hopper, the transistor generation had Radio Shack's Science Fair and "P-Box" kits: the one- and two-transistor radios soldered up on kitchen tables by the thousands. Many were designed and documented by Forrest M. Mims III, whose hand-drawn project notebooks launched a generation of engineers.
The one-transistor radio never had much of a commercial life; the pocket sets you bought at the drugstore used six transistors or more. But that was never the point. Like the one-tube wonder, it was the purest possible demonstration that radio is not magic but understandable craft, and that you could hold the whole working thing, a single amplifying device and a coil of wire, in the palm of your hand. From a tube to a transistor, the lesson stayed the same: with a little knowledge and the simplest of parts, the airwaves are yours.
Sources: Wikipedia (CK722; 2N107); Computer History Museum / Semiconductor Museum (Jack Ward); OneTubeRadio.com; radioshackcatalogs.com; Hackaday.
© 2026 Chris, N6JET. Free to read and share for non-commercial use with credit (Creative Commons BY-NC 4.0). Not for sale.
All AM radio stories by subject · AM radio interactive tools and simulators · AM Trivia Challenge quiz